How much is LEGO MetalBeard's Duel (70807-1) worth?

MetalBeard's Duel sells for an average of $57.55 used and $108.06 new/sealed on BrickLink based on 6 months of completed sales. As a retired set, prices tend to hold steady or appreciate over time, especially for complete sets with original packaging. Actual prices vary with completeness. Missing minifigures or key parts will lower the value.

What minifigures come in LEGO set 70807-1?

This set includes 3 minifigures: Robo SWAT - Helmet ($1.94), Frank the Foreman ($2.29), Robo Skeleton ($2.32). The minifigures have a combined BrickLink value of $6.56. Each figure is linked above with individual pricing if you're looking to buy or sell specific characters.

Is it worth parting out LEGO MetalBeard's Duel?

The minifigures make up about 11% of the set value ($6.56 out of $57.55). Most of the value is in the complete set package, so selling it whole is likely the better move unless you have buyers lined up for specific figures.

Is LEGO MetalBeard's Duel (70807-1) retired?

Yes, MetalBeard's Duel was released in 2014 and has been retired from retail for several years. Retired LEGO sets are only available on the secondary market through BrickLink, eBay, or other resale platforms.

How do I check if my MetalBeard's Duel set is complete?

Use the parts list on this page to check every piece and all 3 minifigures. For the minifigures specifically, you can use the brick'em scanner to identify each figure from a photo and confirm it matches what should be in this set. Missing pieces can be individually sourced on BrickLink.

MetalBeard's Duel

70807-1·Scooby-Doo·2014·3 minifigs·167 parts

Used Avg

$57.55

New Avg

$108.06

Add to your inventory Scan the minifigs

About MetalBeard's Duel

MetalBeard's Duel (70807-1) is a LEGO Scooby-Doo set released in 2014, currently averaging $57.55 used on BrickLink. It comes with 3 minifigures worth a combined $6.56. The set has retired from retail, so secondary market is the only option. The full parts inventory runs 167 pieces.

Parts (167)

Plate, Modified 2 x 2 with Pin Hole - Full Cross Support Underneath

×3

Hero Factory Weapon, Blade with Curved Tip

Slope, Curved 2 x 1 x 2/3

×8

Slope, Curved 2 x 1 x 2/3

×5

Shark Body with Debossed Gills

Plate, Modified 2 x 2 with Curved Minifigure Head Holder

Minifigure, Weapon Gun, Blaster with Clip

Brick 2 x 2 Corner

×2

Tile, Modified 1 x 2 Grille with Bottom Groove

×5

Tile, Modified 1 x 2 Grille with Bottom Groove

×2

Plate 2 x 2 Corner

×2

Plate 2 x 2 Corner

×6

Hinge Plate 1 x 4 Swivel (2429 / 2430)

×4

Tile 1 x 4

×3

Tile, Modified 1 x 2 with Bar Handle

×2

Bracket 1 x 2 - 1 x 4 with Rounded Corners

×3

Minifigure, Visor Standard

Container, Barrel 2 x 2 x 2

Minifigure, Headgear Hat, Pirate Bicorne with Minifigure Skull and Wrenches Crossbones Pattern

Plate, Modified 1 x 2 with Bar Handle on Side - Free Ends

Bird, Parrot with Small Beak

Tile, Modified 1 x 1 with Clip

Minifigure, Weapon Gun, Flintlock Pistol

×2

Plate, Round 2 x 2 with Rounded Bottom (Boat Stud)

×4

Technic, Pin with Short Friction Ridges

×2

Brick, Modified 1 x 2 with Grille / Fluted Profile

Brick 2 x 4

Brick 2 x 2

Brick 1 x 2

×2

Brick 1 x 2

×2

Brick 1 x 6

×2

Brick, Modified 1 x 2 with Log Profile

Minifigure, Utensil Binoculars Town

×2

Plate 2 x 4

×2

Plate 2 x 3

×3

Plate 2 x 3

Plate 2 x 2

×4

Plate 2 x 2

×2

Plate 1 x 2

×14

Plate 1 x 2

×7

Bar 4L (Lightsaber Blade / Wand)

Hinge Brick 1 x 4 Locking with 1 Finger Vertical End and 2 Fingers Vertical End

×4

Slope 45 2 x 1

×2

Slope 45 2 x 1

×4

Brick, Modified 1 x 4 with Studs on Side

×3

Slope 45 2 x 1 Double / Inverted with Bottom Stud Holder

Hinge Cylinder 1 x 2 Locking with 2 Fingers and Axle Hole on Ends with Slots

×2

Hinge Cylinder 1 x 3 Locking with 1 Finger and 2 Fingers on Ends, with Hole

×4

Slope, Curved 2 x 2 Lip

×2

Brick, Round 1 x 1

×4

Brick, Round 1 x 1

×4

Brick 1 x 2 without Bottom Tube

×6

Vehicle, Steering Wheel Small, 2 Studs Diameter

×2

Tile 2 x 2

×3

Tile 1 x 2

×4

Tile 1 x 1 with Black Keyhole and 4 Dots on Silver Background Pattern

×2

Plate, Modified 2 x 3 with Hole

×3

Technic, Axle 2L Notched

×3

Technic, Brick 1 x 2 with Axle Hole

Technic, Gear Knob Cog Wheel with Axle Hole (+ Orientation)

×2

Technic Driving Ring Extension

Technic, Liftarm Thick 1 x 3

×2

Technic, Liftarm Thick 1 x 3

Hot Dog / Sausage

Minifigure, Head Dark Silver Eye Patch with Rivets, Bared Teeth with Copper Tooth, Stubble Pattern (MetalBeard)

Slope, Inverted 45 2 x 2 with Flat Bottom Pin

×3

Slope, Inverted 45 2 x 2 with Flat Bottom Pin

×2

Slope, Inverted 45 2 x 1

×2

Plate 1 x 6

Slope 65 2 x 2 x 2 with Bottom Tube

×2

Technic, Brick 1 x 4 with Holes

Technic, Axle 6L

Technic, Plate 2 x 4 with 3 Holes

×2

Plate 1 x 4

Plate, Modified 1 x 2 with 1 Stud, Jumper (Undetermined Type)

Plate 2 x 6

×2

Technic, Brick 1 x 6 with Holes

×3

Hinge Brick 1 x 2 Base

×2

Brick, Round 2 x 2 with Axle Hole

Plate 6 x 6

×2

Plate, Round 2 x 2 with Axle Hole

×3

Plate, Round 2 x 2 with Axle Hole

Plate, Round 1 x 1

×4

Plate, Round 1 x 1

×11

Plate, Round 1 x 1

×8

Plate, Modified 1 x 1 with Light Attachment - Thick Ring

×2

Hinge Brick 2 x 2 Locking with 2 Fingers Vertical and Axle Hole

×2

Hinge Cylinder 1 x 3 Locking with 1 Finger and Pin with Round Hole and Friction Ridges on Ends

×2

Wedge 6 x 2 Right

Wedge 6 x 2 Left

Technic, Pin 1/2 without Friction Ridges

×13

Technic, Axle 1L with Pin with Friction Ridges

Hinge Plate 1 x 2 Locking with 1 Finger on Side (Undetermined Type)

×2

Bracket 1 x 2 - 2 x 2

×4

Flag 4 x 1 Wave Right

Cone 1 x 1 with Top Groove

Plate, Modified 1 x 2 with Bar Arm Up (Horizontal Arm 5mm)

Container, Treasure Chest Bottom with Slots in Back

Container, Treasure Chest Lid Curved with Thick Hinge

Dish 2 x 2 Inverted (Radar)

Technic Rotation Joint Ball Loop with 2 Perpendicular Pins with Friction

×2

Slope, Curved 3 x 2 x 2/3 with 2 Studs, Wing End

Slope, Curved 2 x 2 x 2/3 with 2 Studs and Curved Sides

×4

Bar 12L with Open Stud, Tow Ball, and Slit (Boat Mast)

Boat, Ship's Wheel with Slotted Pin

Technic, Brick Modified 2 x 2 with Pin Hole and Rotation Joint Ball Half Vertical

×2

Technic, Brick Modified 2 x 2 with Pin Hole and 2 Rotation Joint Sockets

Plate, Modified 1 x 2 with Bar Handle on Side - Closed Ends

×4

Bar 1L with Clip Mechanical Claw - Cut Edges and Hole on Side

×4

Slope, Curved 3 x 1

×2

Barb / Claw / Horn / Tooth - Small

×9

Technic Ball Joint with Through Axle Hole

×2

Slope 30 1 x 1 x 2/3

×9

Technic, Brick Modified 2 x 2 with 2 Ball Joints

×2

Technic, Brick Modified 2 x 2 with Ball Joint and Axle Hole with 6 Holes in Ball

Bar with Light Cover (Bulb) / Bionicle Barraki Eye

×4

Arm Mechanical, Straight with Clips at 90 degrees (Vertical Grip)

Plate, Modified 1 x 2 with 2 Open O Clips (Horizontal Grip)

×2

Plate, Round 4 x 4 with Hole

Brick, Modified 1 x 1 with Open O Clip (Vertical Grip) - Hollow Stud

Plate, Modified 1 x 2 with Bar Handle on End

×4

Slope, Curved 2 x 1 x 1 1/3 with Recessed Stud

×4

Technic, Pin 1/2 with 2L Bar Extension (Flick Missile)

×2

Hinge Brick 2 x 2 Top Plate

×2

Slope 18 2 x 1 x 2/3 with Grille

×5

Slope 18 2 x 1 x 2/3 with Grille

Technic, Pin Connector Round 2L with Slot (Pin Joiner Round)

Ice Cream Scoops

Leg Skeleton

Plate, Modified 1 x 2 with Clip on End (Horizontal Grip)

×4

Minifigure, Utensil Telescope

Minifigure, Plume Feather Triple Compact / Flame / Water with Small Pin

×2

Technic, Axle Connector 2L (Smooth with x Hole + Orientation)

Technic, Brick 1 x 1 with Hole

×4

Technic, Gear 16 Tooth with Clutch, Smooth

×2

Technic, Pin 3L with Friction Ridges

×2

Technic, Axle 3L with Stud

Technic, Liftarm Thin 1 x 3 - Axle Holes

×2

Plate, Modified 2 x 2 with Bar Frame Octagonal, Reinforced, Completely Round Studs

Tile 2 x 4

×3

Panel 1 x 2 x 2 with Side Supports - Hollow Studs

×2

Plate, Modified 2 x 2 with Groove and 1 Stud in Center (Jumper)

×2

Plate, Modified 2 x 2 with Groove and 1 Stud in Center (Jumper)

Shark Head with Rounded Nose and Debossed Eyes

Technic, Brick Modified 2 x 2 with Ball Socket and Axle Hole - Straight Forks with Round Ends and Open Sides

×4

Chain 5 Links

×4

Bar 1L with Top Stud and 2 Side Studs (Connector Perpendicular)

Plate, Modified 1 x 2 with Angled Bar Handles on Side

Bone, Short

×2

Slope, Curved 4 x 1 x 2/3 Double

Technic, Axle Connector 2 x 3 with Ball Joint Socket - Closed Sides, Straight Forks with Open Axle Holes

Boat, Anchor - Two Top Holes

Tile, Round 1 x 1

×9

Arm Mechanical, Exo-Force / Bionicle, Thick Support

×4

Minifigure, Utensil Toy Winder Key

×2

Bracket 1 x 2 - 2 x 2 Inverted

×5

Bracket 1 x 2 - 1 x 2 Inverted

×6

Bracket 1 x 2 - 1 x 2

×6

Projectile Launcher, Cannon Shooting

×2

MetalBeard's Duel

About MetalBeard's Duel

Part-out value

Seller notes

Minifigures in MetalBeard's Duel (3)

Parts (167)

Common questions about MetalBeard's Duel

How much is LEGO MetalBeard's Duel (70807-1) worth?

What minifigures come in LEGO set 70807-1?

Is it worth parting out LEGO MetalBeard's Duel?

Is LEGO MetalBeard's Duel (70807-1) retired?

How do I check if my MetalBeard's Duel set is complete?

More Scooby-Doo sets

Explore more

Company

Legal