How much is LEGO Excavation Searcher (7316-1) worth?

Excavation Searcher sells for an average of $75.12 used and $102.22 new/sealed on BrickLink based on 6 months of completed sales. As a retired set, prices tend to hold steady or appreciate over time, especially for complete sets with original packaging. Actual prices vary with completeness. Missing minifigures or key parts will lower the value.

What minifigures come in LEGO set 7316-1?

This set includes 3 minifigures: Life on Mars (LoM) Martian - Canopus ($6.10), Life on Mars (LoM) Martian - Pollux ($6.68), Life on Mars (LoM) Martian - Vega ($2.94). The minifigures have a combined BrickLink value of $15.72. Each figure is linked above with individual pricing if you're looking to buy or sell specific characters.

Is it worth parting out LEGO Excavation Searcher?

The minifigures make up about 21% of the set value ($15.72 out of $75.12). Most of the value is in the complete set package, so selling it whole is likely the better move unless you have buyers lined up for specific figures.

Is LEGO Excavation Searcher (7316-1) retired?

Yes, Excavation Searcher was released in 2001 and has been retired from retail for several years. Retired LEGO sets are only available on the secondary market through BrickLink, eBay, or other resale platforms.

How do I check if my Excavation Searcher set is complete?

Use the parts list on this page to check every piece and all 3 minifigures. For the minifigures specifically, you can use the brick'em scanner to identify each figure from a photo and confirm it matches what should be in this set. Missing pieces can be individually sourced on BrickLink.

Excavation Searcher

7316-1·Space·2001·3 minifigs·119 parts

Used Avg

$75.12

New Avg

$102.22

Add to your inventory Scan the minifigs

About Excavation Searcher

Excavation Searcher (7316-1) is a LEGO Space set released in 2001, currently averaging $75.12 used on BrickLink. It comes with 3 minifigures worth a combined $15.72. The set has retired from retail, so secondary market is the only option. The full parts inventory runs 119 pieces.

Part-out value

Parts (119)

Rubber Band Extra Small (Square Cross Section), 7 in Bag (Multipack)

Brick 2 x 2 Corner

×2

Tile, Modified 1 x 2 Grille with Bottom Groove

×10

Tile, Modified 1 x 2 Grille with Bottom Groove

×2

Wedge, Plate 3 x 6 Cut Corners

×2

Plate 2 x 2 Corner

×8

Hinge Plate 1 x 4 Swivel (2429 / 2430)

×16

Tile 1 x 4

×3

Tile, Modified 1 x 2 with Bar Handle

×2

Plate 2 x 12

×2

Wedge, Plate 3 x 3 Cut Corner

×4

Vehicle, Tipper Bed Small

Plate, Modified 1 x 2 with Bar Handle on Side - Free Ends

×13

Technic, Steering Rack

×2

Brick, Modified 1 x 2 with Grille / Fluted Profile

×4

Brick 2 x 4

×2

Brick 2 x 3

×5

Brick 2 x 2

×2

Brick 1 x 2

×10

Brick 1 x 1

Brick 1 x 4

Plate 2 x 4

×4

Plate 2 x 3

×6

Plate 2 x 2

×14

Plate 1 x 2

×35

Plate 4 x 12

Rock 4 x 4 Octagonal Boulder, Top

×2

Rock 4 x 4 Octagonal Boulder, Bottom

×2

Plate, Modified 6 x 6 x 2/3 Cross with Dome

×4

Plate 4 x 4

×2

Plate 4 x 6

Plate 4 x 8

×3

Bar 1 x 8 with Brick 1 x 2 Curved Top End (Original, No Axle Holder)

×4

Hinge Brick 1 x 2 Locking with 1 Finger Vertical End

×9

Hinge Brick 1 x 2 Locking with 2 Fingers Vertical End

×12

Slope, Inverted 65 6 x 6 x 2 Quad with Cutouts

Arm Mechanical, Battle Droid

Hinge Plate 1 x 2 Locking with 1 Finger on Top

×14

Hinge Brick 1 x 6 Locking with 1 Finger Vertical End and 2 Fingers Vertical End

×11

Hinge Brick 2 x 2 Locking with 1 Finger Vertical and Axle Hole

Slope 45 2 x 2

×12

Hinge 1 x 2 Locking with 2 Fingers and Tow Ball Socket

×2

Slope 45 2 x 2 with Life on Mars (LoM) Elliptical Display Pattern

Slope 45 2 x 1

×6

Slope 45 2 x 1

×4

Brick, Modified 1 x 2 with Pins

×5

Brick, Modified 1 x 2 with Pins

×3

Arch 1 x 8 x 6 (Portal)

×2

Windscreen 8 x 4 x 2 Curved Taper with Locking Dual 2 Fingers

Arm Grabber Angled

×4

Hinge Cylinder 1 x 2 Locking with 2 Fingers and Axle Hole on Ends with Slots

×6

Brick, Modified 2 x 4 with Pin on Top and Side Cutouts

Rock 2 x 2 with Center Stud

×2

Brick, Round 1 x 1

×12

Brick, Round 1 x 1

×4

Brick, Round 1 x 1

Tile 2 x 2

Tile 1 x 2 with Life on Mars (LoM) Elliptical Display Pattern

×3

Technic, Brick 1 x 2 with Holes

×6

Technic, Brick 1 x 2 with Holes

Technic, Axle and Pin Connector Angled #6 - 90 degrees

×4

Wedge, Plate 4 x 6 Cut Corners

Technic, Pin Double with Axle Hole

Technic, Panel Fairing # 1 Large Short, Large Holes, Side A

Technic, Panel Fairing # 2 Large Short, Large Holes, Side B

Slope 33 3 x 2

×11

Turntable 4 x 4 Square Base with (Same Color) Top (3403 / 3404)

Plate 1 x 8

×2

Slope, Inverted 45 2 x 2 with Flat Bottom Pin

×3

Slope, Inverted 45 2 x 2 with Flat Bottom Pin

×6

Plate 1 x 6

Technic, Brick 1 x 2 with Hole

×2

Plate 1 x 4

×3

Plate 1 x 4

Slope, Inverted 33 3 x 2 with Flat Bottom Pin without Connections between Studs

×4

Technic, Axle 1L with Pin without Friction Ridges with Round Hole

×4

Plate 2 x 6

Plate 2 x 10

Hinge Brick 1 x 2 Base

Hinge Brick 1 x 2 Top Plate

Brick, Round 2 x 2 with Axle Hole

Cone 2 x 2 x 2 - Open Stud

Plate, Round 2 x 2 with Axle Hole

×4

Brick, Modified 1 x 1 with Headlight

×4

Plate, Round 1 x 1

×16

Plate, Modified 1 x 1 with Light Attachment - Thick Ring

×2

Plate, Modified 1 x 1 with U Clip Thick (Vertical Grip)

Tile, Round 2 x 2

×4

Tile, Round 2 x 2

×4

Tile, Round 2 x 2 with Orange Grabber Pattern

×3

Plate 2 x 16

Dish 6 x 6 Inverted (Radar) Webbed - Type 2 (Underside Attachment Positions at 90 degrees)

Minifigure, Utensil Loudhailer / Megaphone / SW Blaster

Support 2 x 4 x 5 Stanchion Inclined, 5mm Wide Posts

×4

Plate 1 x 10

×2

Technic, Axle 3L

×4

Cone 1 x 1

×6

Cone 1 x 1

Bar 1 x 3 with Clip and Stud Holder (Robot Arm)

×2

Dish 2 x 2 Inverted (Radar)

×7

Wedge 4 x 4 Triple without Stud Notches with Brown Panels, Light Gray Machinery, and Light Lime Oval Pattern

×5

Bracket 5 x 2 x 2 1/3 with 2 Holes

Brick 1 x 12

×2

Slope, Curved 3 x 2 with 4 Studs

×2

Technic, Brick 1 x 1 with Hole

Technic, Axle 2L with Reverser Handle Axle Connector

×6

Technic, Pin 3L with Friction Ridges

×2

Plate, Modified 1 x 6 with Train Wagon End / Fence

×2

Technic, Axle 3L with Stud

×3

Technic, Pin Connector Round 2L without Slot (Pin Joiner Round)

×2

Hose, Ribbed 7mm D. 13L / 10.4cm

×2

Excavation Searcher

About Excavation Searcher

Part-out value

Seller notes

Minifigures in Excavation Searcher (3)

Parts (119)

Common questions about Excavation Searcher

How much is LEGO Excavation Searcher (7316-1) worth?

What minifigures come in LEGO set 7316-1?

Is it worth parting out LEGO Excavation Searcher?

Is LEGO Excavation Searcher (7316-1) retired?

How do I check if my Excavation Searcher set is complete?

More Space sets

Explore more

Company

Legal